You can see the cavity in which the motor mounts; there are two "D" shaped brackets on the motor that allow it to be screwed into the bottom of the large metal "hump" that takes up the center of the cab area. Removing the one at the non shaft end allows the motor to come completely out. And, any earlier questions about the frame are answered; the black and gray areas are all one piece and the "hump" is an integral part. The whole frame is metal, by the way, which makes gluing and drilling a little different from what you might be used to on a plastic locomotive! Here also you can see the bottom end of the power truck, consisting of the gearbox and axles. It's held to the bottom of the deck by four standoffs that are cast into the floor, and when removed has a strange strong resemblance to an HO power truck (only much larger.)
Now, the trick will be to get all of the various components arranged and mounted, and the wires between them run, and organized. It looks like the power switch and radio receiver will go under the cab between the frame rails, and the speaker will go up front under the frame just below the factory supplied speaker grille (which has beene removed.) Everything else has fit under the hood, and the standard rear charging / aux power jack will be concealed on the fireman's side of the cab, and will resemble a sand fill and sand box with a seat on top. I plan to redo the engineer's side of the cab somewhat, as I'm not thrilled with the size or position of the factory control surfaces. We even have an engineer enroute from Hawaii to take charge of things once the unit is operational (thanks Richard!) although I suspect he may have to be temporarily assigned to K-27 duty ... and it may be hard to get him to step down to the little 10 tonner after that!Stay tuned ... there's more coming!
No comments:
Post a Comment